Installation guide for DIY mounting of the roof and side protection on the Sharebox Service Station S18.
Weather Protection Kit - Installation Guide
Introduction
The Sharebox Service Station is a free-standing safe according to EN1143-1:2019, designed for key-exchange, more specific to hold and exchange car-keys. The user can deliver a car-key and/or pick up a car-key, typically outside a car dealership, workshop or car-rental-facility.
The cabinet is connected to a back-end server, and the user communicates with this server to get access to the key.
Technical Description
The Weather protection for the Service Station is made from Aluminium and steel. Its powder coated with RAL 9006.
This manual will describe how the weather protection shall be installed properly
Contact Info
If any support is needed in the installation do not hesitate to contact us either via;
Sharebox Support: +47 40 43 44 44 or by mail: operations@sharebox.global
How to do installation
A. Install the legs
Install the legs on each side of the cabinet. The legs have 2 predrilled holes on each side. Use 2 pcs M10x25 bolt and M10 washer.
B. Open the door
In order to open the door, you need to contact Sharebox Support to obtain the 6-digit pin code. Then use the given pin code on the left-top side of the cabinet. As described below. Open the lock in a clockwise rotation.
When pincode is pushed and lock-handle is turned to OPEN position you can open the door. This is done by using a wrench with size 17mm on the top bolt. In order to open, the bolt needs to be tightened (RED CIRCLE). The door needs to be “lifted” until it touches the small black POM plate behind the bolt.
NOTE: The door must not be opened more than 84 degrees, as cables can be pulled/stretched more than intended. And if not fixed to floor, the cabinet can fall over to the side.
When the door is opened the two predrilled holes on the top of the backframe is accessible. The legs of the weather protection can now be fixed with three DIN 603 M12x45mm A2 grade bolts.
Look at below figure:
C. Installing the roof
The roof is lowered and fixed with 6pcs M8x16mm bolt. The roof is tilted gently against the backend and the all the bolts are fixed.
D. Installing cover plate for roof
The cover plate is lifted up against the roof. NOTE the flange must be up. The roof is fitted and adjusted with 8 pcs M5x10 torx screws.
E. Installing side plate
The side cover is fitted with 3pcs M8 nut and M8 washer.
F. Close the door
Close the door carefully and make sure that no cables are squeezed.
Hold the door and use the wrench in order to lower the front door. When the top of the door is flushed with the back top, the door is lowered enough. To lock the cabinet, use the handle on the backdoor lock on the top right corner and turn it counterclockwise to the left (as shown below). 
